• The Motor Guard M-26 Plasma air filter increases the efficiency and tip life of your plasma cutter by removing moisture and oil aerosols from your compressed air line
• Eliminate arc "Sputter"
• Restore the plasma system to maximum cutting efficiency
• Reduce corrosive wear of the electrode and tip
• This filter is equipped with a mounting bracket that will facilitate an installation on the top, side or rear panel of the smaller, portable plasma cutting systems
• The filter is equipped with 1/4 Inch NPT ports to match the fittings on most plasma systems and has a rated air flow of over 2700 scfh
• Replacement air filter elements are available via Welder source part # M723
• Maximum pressure: 125 psi
• Removal rating: 0.01 micron (nominal)
• Max. Floor at 80 psi: 2700 scfh

Motor Guard M26 Air Filter, Connection: 1/4 Inch NPT, 5 Inch x 7 Inch, Temperature: 175 deg F