XTra Performance! XTra Power! XTra Protection! get all of the XTras needed for construction and maintenance work. That's XTra welding performance with 250 amp for AC or DC stick and DC wire welding and XTra power with up to 11000 watt peak for lights, grinders or high amperage equipment. You also get XTra protection and quiet operation with the Lincoln enclosed case. Kohler® warranty is 3 yr. Painted roof, case sides and engine doors
- Totally enclosed case: engine is fully protected, 3 service access doors
- Low noise: 76.4 dBA sound level at 23 ft 100.7 dB sound power (Lwa) at rated output
- Choose from painted or stainless steel roof, case sides and engine doors
- Versatile AC/DC welding
- AC/DC welding output for a broad range of stick electrode types
- Excellent AC TIG welding with optional TIG module and either a foot or hand Amptrol™ for aluminum and other alloy welding
- MIG and flux-cored capable (with optional equipment)
- Remote ready - 6-pin connector and local/remote switch for remote control operation
- 11000 watt peak 1-Phase AC generator power
- Peak for motor starting, 10000 watt continuous power for generator, plasma cutter or inverter welder
- Lights, grinder, power tools
- Electric fuel pump avoids vapor lock
- Oil drain extension for easy oil changes
- Electric fuel gauge located on control panel makes it easy to check the fuel level during operation and refueling
- Gasoline engine aluminum alloy with cast iron liners electric fuel pump, 12 volt battery 435 cold cranking amp manual choke
Lincoln® Ranger® K2382-4 250 GXT Engine Driven Welder, Rated Output: 250 amp AC/DC At 25 volt, 100% Duty Cycle, Welding Amperage Range: 50 - 250 amp AC/DC, Generator Power: 11 kilowatt Peak, 10 kilowatt Continuous, Engine: Kohler® OHV Command CH730 2-Cylinders 44 cu. in. 3600 Rpm 23 hp Electric Start Air Cooled Gasoline, Fuel Type: Gas, Fuel Capacity: Fuel: 12 gal, Oil: 1.9 L, Fuel Consumption: 1.7 gph At 250 amp Full Load, 0.9 gph At 3700 Rpm, 0.4 gph 2400 Rpm, Outlets: (2) 120 volt Duplex Receptacles 20 amp Per Duplex, 120/240 volt Receptacle 42 amp Each 120 volt Branch, Welding Process: Stick, TIG, MIG, Flux Cored, Gouging, 36.2 Inch Height x 21-1/2 Inch Width x 42.3 Inch Length, Weight: 602 lb